German Leopard 2A6 - TK40SPG2
Clark Electronics
TK40SPG2-L2
ex Shipping
    Delivery time:14 Days
Add to cart
  • Description
  • More

This is the G variant TK40 controller uses 10-CH S-BUS multi-function unit to control R/C tank's forward/backward movement, sharp turning, pivoting, turret rotation and gun barrel evaluation at variable speed. The G variant provides Gun barrel stabilization making the tank movement more realistic.

This multi-function controller has the following characteristics:

  • Ultrasonic ESC*3 for two track motor and turret rotation
  • Carefree reversing
  • Ultra Low turn-on resistance FET for track motor ESC
  • Support Gun Barrel Stabilizer ( G2 Variant )
  • 22KHz, 8-bit high quality sound with digital sound mixer
  • Maximum of 5 channel of sound track, main gun, machine gun, turret rotate, gun barrel elevation and engine sound can be generated at the same time
  • 3W sound output power, 8-Ohm Speaker is recommended
  • 0.8A BEC
  • EPM*2 for gun elevation(EPM1) and turret rotation/gun traverses(EPM2)
  • Wide operating voltage rage, from 7.2 to 12V, support 3S Li-Po battery
  • Support air-soft gun with sound synchronization
  • Support TAMIYA and HL IR battle unit and format
  • Support RealRecoil servo port
  • Support Recoil Solenoid for 2nd Machine Gun( MG2 )
  • G variant Support gun barrel stabilizer
  • Safety shutoff prevents unwanted movement while signal lost
  • Miniature design(60mm X 50mm X 20mm) for 1/25~1/16 R/C Tank
  • V2 Smoker driver
  • Adjustable Low Battery threshold

Terminology

  • Ultrasonic ESC is the ESC block which switch FET at ultrasonic speed, make motor rotation extreme  smooth and quite. start voltage of ESC can also be adjusted for different type of motor.
  • Carefree reversing: Unlike some other control board, there is no need for TK series board to delay before being commanded to reverse, can go from full forward immediately to full reverse or vice versa
  • EPM ( ESC/PWM module) is peripheral which can be switched to ESC or PWM mode, allows the user to drive brushed motor or servo motor, in ESC mode, ESC port is enabled, can be used to drive brushed motor, In PWM mode, PWM port is enabled to driver servo motor, sound effect stopped when servo motor reach end point, TK40 has 2 EPMs for gun elevation(EPM1) and turret rotation/gun traverses(EPM2),